Brocade Communications Systems 8 Command Reference Manual page 200

2
cryptoCfg
•
If rekey- or tape sessions are in progress, the command shows:
•
•
•
•
Use the --show -rekey command to display all rekey sessions in progress on the current node or
for a specified container. The display includes the following information:
•
•
168
For each LUN:
-
LUN number: numeric identifier
-
LUN type: disk, tape drive, tape medium changer, tape attached medium changer,
offline/unknown, or unsupported/other
-
LUN status: numeric value
-
Encryption mode: encrypt or cleartext
-
Encryption format: native or DF compatible
-
Tape policy type: pool-based or LUN-based
-
Encrypt existing data: disabled or enabled
-
Rekey: disabled or enabled
-
Key ID state: Read, Write, or Key ID not applicable
-
Key life (in days): numeric value
-
Volume/pool label: user-defined label
-
Rekey status: numeric value
Number of rekey sessions in progress: numeric value
For each rekey session the display includes:
-
Rekey session number: numeric value
-
Percent completion: numeric value
-
Rekey state: Read or Write phase
-
Tape volume/pool Label: user-defined label
-
Tape state: mounted or unmounted
-
Tape policy configuration details:
•
Tape pool or tape
•
Encryption or Cleartext
•
Key life span in days
•
Encryption Algorithm
•
Compression Algorithm
Number of Tape sessions in progress: numeric value
For each Tape session the display includes:
-
Tape Session Number: numeric value
-
Number of uncompressed blocks: numeric value
-
Number of compressed blocks: numeric value
-
Number of uncompressed bytes: numeric value
-
Number of compressed bytes: numeric value
Number of rekey sessions in progress: numeric value
For each rekey session, the display includes:
-
Container name: user-define label
Fabric OS Command Reference
53-1001764-02