Brocade Communications Systems 8 Command Reference Manual page 507

Associated physical ports
When lfCfg is issued within a logical switch context, only the configuration regarding that switch
and the fabrics reachable from that switch is displayed. When the command is issued in a chassis
context the information for all chassis in the base fabric reachable from the current chassis is
displayed. Executing chassis-level commands requires chassis permissions. Refer to the
userConfig command for information on setting chassis user permissions.
Notes The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS Commands" and Appendix A, "Command
Availability" for details.
This command is supported only on hardware platforms that are Virtual Fabric-aware and run
Fabric OS v6.2.0 or later. Refer to the Fabric OS Administrator's Guide for specific hardware
support.
You cannot use the portEnable command on logical ports. Use lfcfg with the --lislenable option to
re-enable disabled LISL ports on a logical switch.
Operands This command has the following operands:
--show -cfg
--showall -cfg
--show -lisl
--showall -lisl
--show -xisl [slot]port
--showall -lisl
--lislenable
--help
Fabric OS Command Reference
53-1001764-02
Physical ports associated with the LISL ports.
Displays information for the fabric ID set by the context in all chassis
reachable from the base fabric.
Displays information for all fabrics in all chassis reachable from the chassis
context in which the command is executed. This option requires chassis
permissions.
Displays status information about the LISLs in the logical switch set by the
context.
Displays status information of all LISLs in the chassis. This option requires
chassis permissions.
-v Displays, in addition to the LISLs, the physical ports on the base switch that
are associated with the LISL ports. This operand is optional with the -lisl
option.
Displays the XISL and the LISLs associated with it for the specified XISL port.
For each LISL port, the output displays the FID, LISL State (online/offline) and
the local and remote logical switch WWNs. This command must be executed
from the base switch.
Displays the XISL connections between two base switches for all XISL ports.
This command must be executed from the base switch.
Re-enables all LISLs in the fabric that were disabled because of some conflict
or error condition in the fabric. This command provides the option of manually
reestablishing the LISLs after the error condition has been resolved.
Displays the command usage.
2
lfCfg
475