Fwportdetailshow - Brocade Communications Systems 8 Command Reference Manual

fwPortDetailShow

Displays the port information for specified user ports.
Synopsis fwportdetailshow [--p port] | [--s portState]
Description Use this command to print the overall status of a specified port. The output of this command is
different for IPv4 and IPv6 addresses. The overall status is calculated based on the following
contributors:
Port Errors:
SFP Errors:
The overall status may be in one of the following:
If the overall status is not healthy, the contributing factors also are listed.
Notes This command requires a Fabric Watch license.
Port errors are not supported for virtual ports and SFP errors are not applicable for virtual ports.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operands:
--p port
Fabric OS Command Reference
53-1001764-02
LFA Number of link loss occurrences exceeded limit for time period
LSY Number of sync loss occurrences exceeded limit for time period
LSI Number of signal loss occurrences exceeded limit for time period
PER Number of protocol errors exceeded limit for time period
INW Number of invalid words exceeded limit for time period
CRC Number of invalid CRC errors exceeded limit for time period
PSC Port hardware state changed too often
BLP Buffer limited port
STM SFP temperature is out of specification
SRX SFP receive power is out of specification
STX SFP transmit power is out of specification
SCU SFP current is out of specification
SVO SFP voltage is out of specification
Healthy Every contributor is healthy
Marginal One or more contributors are in this status
Faulty Faulty hardware
Offline Port has no connectivity or is disabled
Yields a port detail report for a specific user port.
2
fwPortDetailShow
373