Brocade Communications Systems 8 Command Reference Manual page 917

Fabric os command reference manual supporting fabric

Hide thumbs Also See for 8:

Table of Contents

Fabric OS Command Reference

53-1001764-02

-mib_name mib_name

Specifies the name of the MIB to be configured. This operand is required if

you want to configure MIB traps noninteractively. Valid MIB names include

the following.

-bitmask bit_mask

Specifies the bit mask for the MIB. In Fabric OS v6.4.0 and later, SNMP Traps

are identified by their bit mask and can be read directly from the switch

configuration. The MIB and trap status (enabled or disabled) status is

recorded in a 64- bit counter. The last bit (bit 0) is reserved for the MIB and

the remaining bits are reserved for the traps of that MIB. The trap's position is

allocated based on the last ID of the trap OID. For example, the last ID of the

swEventTrap is 5 so its position will be 5th from the right. Refer to

for a listing of valid bit masks.

SNMP Trap bit mask values

(Fibre Channel FE evants)

(switch events)

swFabricWatchTrap

swTrackChangeTraps

swIPv6ChangeTrap

swPmgrEventTrap

swFabricSegmentTrap

swFabricReconfigTrap

(fabric events)

connUnitStatusChange(1)

connUnitAddedTrap (2)

connUnitDeletedTrap (3)

connUnitEventTrap (4)