Brocade Communications Systems 8 Command Reference Manual page 692

2
portCfgLongDistance
Examples To configure a switch port 63 to support a 100 km link and be initialized using the long distance
link initialization protocol:
See Also configure, portCfgISLMode, portCfgTrunkPort, portCfgShow, portShow, switchShow
660
desired_distance, this value is used to allocate the buffers. In this case, the
port operates in degraded mode instead of being disabled due to insufficient
buffers. In LS mode, the actual link distance is not measured, instead the
desired_distance is used to allocate the buffers required for the port.
switch:admin> portcfglongdistance 4/15 LS 1 100
switch:admin> portshow 4/15
portCFlags: 0x1
portFlags: 0x20001
portType: 1.1
portState: 2 Offline
portPhys: 4 No_Light
portScn: 0
portId: 013f00
portWwn: 20:3f:00:60:69:00:02:48
Distance: super long <= 100km
portSpeed: 2Gbps
Interrupts: 9
Unknown: 0
Lli: 9
Proc_rqrd: 0
Timed_out: 0
Rx_flushed: 0
Tx_unavail: 0
Free_buffer: 0
Overrun: 0
Suspended: 0
Parity_err: 0
2_parity_err: 0
CMI_bus_err: 0
PRESENT LED
Link_failure: 0
Loss_of_sync: 0
Loss_of_sig: 9
Protocol_err: 0
Invalid_word: 0
Invalid_crc: 0
Delim_err: 0
Address_err: 0
Lr_in: 0
Lr_out: 0
Ols_in: 0
Ols_out: 0
Frjt: 0
Fbsy: 0
Fabric OS Command Reference
53-1001764-02