Brocade Communications Systems 8 Command Reference Manual page 778

2
portShow
Protocol
portPhys
portScn
port generation number
portId
portIfId
portWwn
portWwn of devices(s) connected
Distance
Port part of other AD
portSpeed
LE domain
FC FastWrite
If the port is configured as an EX_Port, the following additional port information is displayed:
EX_Port Mode
Fabric ID
Front Phantom
Pr Switch Info
746
Protocol used by the port: FC or FCoE.
The port's physical state:
No_Card No interface card present.
No_Module No module (GBIC or other) present.
No_Light Module is not receiving light.
Mod_Inv Incompatible vendor or module speed mismatch.
No_Sync Receiving light but out of sync.
In_Sync Receiving light and in sync.
Laser_Flt Module is signaling a laser fault.
Port_Flt Port marked faulty.
Diag_Flt Port failed diagnostics.
Lock_Ref Locking to the reference signal.
The port's last State Change Notification.
The port's generation number for the last offline state change.
The port's 24-bit port ID.
The user port's interface ID.
The port's world wide name.
The World Wide Port Names of connected devices.
The port's long-distance level. In the case of LD mode, the user configured
distance and actual distance also are displayed. See portCfgLongDistance for
information on long distance levels.
Yes or No.
The port's fixed speed (1, 2, 4, or 8 Gbps) or negotiated speed (N1 Gbps, N2
Gbps, N4 Gbps, N8 Gbps or AN).
The LE domain ID.
The status of FC FastWrite (ON or OFF).
The port is configured as an EX_Port.
The fabric ID assigned to this EX_Port; this is the fabric ID of the edge fabric
attached to this EX_Port.
Information on the front phantom domain presented by this EX_Port. Includes
the preferred (if not active) or actual (if active) domain ID for the front domain
and the WWN of the front domain.
Information on the principal switch of the edge fabric attached to this
EX_Port. Includes the domain ID and WWN of the principal switch.
Fabric OS Command Reference
53-1001764-02