Brocade Communications Systems 8 Command Reference Manual page 965

On the Brocade 8000, the Proto column identifies the FCoE ports of the switch. For all FCoE ports,
the speed is 10 Gbps. The default configuration of an FCoE port is an F_Port configuration. After a
successful reboot switchShow displays all FCoE ports as online. For each FCoE port, the FCoE
controller WWN is shown. FCoE ports are not configurable with the Fabric OS port commands. Use
the fcoe commands instead.
If a port is configured as a long distance port, the long distance level is displayed in the format of
Lx, where x represents the long distance level number. See portCfgLongDistance for the level
description.
The port state for disabled E_Ports displays as In_Sync when the port is the interswitch link (ISL)
between a Brocade 48000 and a Brocade 24000. If the ISL is between a Brocade 48000 and a
Brocade 4100 or 200E, the disabled E_Port displays as No_Sync.
On a Brocade 7600 switch, if the SAS image is not consistent with the FOS image, the message
"SAS Virtualization Disabled"
When a port is configured as an N_Port and is online, switchShow displays its type as an N_Port.
Also, switchShow displays the WWN of the border switch attached to this N_Port as a 24-bit Port
Identifier assigned to this port by the enterprise fabric.
In an AD context, if one of the L_Ports or NPIV Ports is a part of the current AD, the complete device
information attached to the port is displayed.
Operands This command has the following operands:
-slot slot
-portname
-portcount
-iscsi
Examples To display the port count:
To display GbE ports with iSCSI sessions:
To display a QoS-capable Core Access Gateway with online AoQ F_Ports and N_Ports:
Fabric OS Command Reference
53-1001764-02
Displays blade information. You can specify this operand with -portname, but
not with any other operand.
Displays the name for each port on the switch. The port name is set by the
portName command. You can specify this operand with -slot, but not with any
other operand.
Displays the number of ports on the switch. This operand is exclusive.
Displays the number of ports on the iSCSI sessions associated with GbE ports
in a switch. This operand is exclusive.
switch:admin> switchshow -portcount
FC ports = 198, GE ports =
switch:admin> switchshow -iscsi
Ports of Slot 1 ge0 ge1 ge2 ge3
-----------------+---+---+---+---+-----+---+---+---
Sessions 0
switchshow
switch:admin>
switchName: Spirit_125
switchType: 66.1
switchState: Online
switchMode: Access Gateway Mode
switchWwn: 10:00:00:05:1e:85:95:d0
switchBeacon: OFF
FC Router: OFF
is displayed.
12
ge4 ge5 ge6 ge7
0 0 0 0 0
switchShow
0 0
2
933