Brocade Communications Systems 8 Command Reference Manual page 210

2
cryptoCfg
--manual_rekey
--resume_rekey
--discoverLUN
--show -container
178
Performs a manual rekeying of a specified LUN associated with a specified
CTC. Manual rekeying is performed in both online and offline fashion
depending on whether or not the host is online or host I/O is present. If any
policy-based rekeying operation is currently in progress, this command aborts
with a warning message. This command is valid only on the group leader.
The following operands are supported:
crypto_target_container_name
Specifies the name of the CTC to which this LUN belongs.
LUN_Num Specifies the number of the LUN to be rekeyed. Use --show -container for a
list of LUN numbers associated with the specified CTC.
initiator_PWWN Specifies the port WWN of the initiator for the specified LUN.
-include_mirror Initiates a manual rekey on an mirror LUN or on a primary LUN in read-only
state. This operand is required if the specified LUN is an mirror LUN or a
primary that has been restored from an out-of-sync mirror LUN.
Performs a manual rekey operation on all encrypted primary or nonreplicated
-all
LUNs on the node that are in read-write state. This operation may take an
extended period of time.
-include_mirror Initiates a manual rekey operation on all primary LUNs and mirror LUNs in
read-only state. In addition, this command also starts a manual rekey
operation on all primary and and nonreplicated LUNs in read-write state.
Resumes a suspended rekey session for a specified disk LUN at the
termination point. A rekey session may terminate prematurely due to
unrecoverable medium or hardware errors. When a rekey session terminates
prematurely, the system logs CRITICAL RASlog and rekey operation failure
status messages. You must take corrective action to clear all error conditions
that caused the rekey failure before resuming a suspended rekey session. All
DEK or HA cluster members must be online and reachable for this operation
to succeed.
crypto_target_container_name
Specifies the name of the CTC to which the LUN belongs.
LUN_Num Specifies the number of the LUN to be rekeyed. Use --show -container for a
list of LUN numbers associated with the specified CTC.
initiator_PWWN Specifies the initiator port WWN for the specified LUN.
Performs LUN discovery. This command discovers and displays all LUNs that
are discoverable by the initiators of a specified CTC. This command is valid
only on the node that hosts the CTC. The following operand is required:
crypto_target_container_name
Specifies the name of the CTC.
Displays all CTCs in the encryption group. This command is valid on all nodes.
The following operands are supported:
-all -cfg Displays the configuration for all containers in the encryption group.
-all -stat Displays the runtime status for all containers hosted on the local node only.
Fabric OS Command Reference
53-1001764-02