Brocade Communications Systems 8 Command Reference Manual page 658

2
portCfg
Examples To create an FCIP tunnel (and default circuit 0) with a committed rate of 10000 Kbps on a Brocade
FX8-24:
To create another FCIP circuit (circuit 1) on the same switch:
626
comm_rate
Specifies the committed traffic rate on the FCIP tunnel in Kbps. The valid
range is 10000 Kbps to 1000000 Kbps. There is no default. Both sides
of the tunnel must have matching configurations.
-b |--min-comm-rate value, -B |--max-comm-rate value
Alternately you can set a minimum and a maximum for the committed
rate to configure the tunnel for Adaptive Rate Limiting (ARL), which allows
for a more effective sharing of bandwidth between applications. The valid
range is 10000 Kbps to 1000000 Kbps. The maximum committed rate
can be no larger than five times the minimum committed rate, and both
sides of the circuit must have matching configurations.
modify [circuit_ID] [circuit_arguments]
Modifies the properties of an existing FCIP circuit. To modify a circuit, you
must specify at least one of the optional circuit parameters for the command
to be effective. Any circuit attribute you change with the fcipcircuit modify
command affects only the specified FCIP circuit. All other circuits remain
unchanged.
Refer to fciptunnel create and modify for a listing of optional circuit
arguments and their descriptions.
delete circuit_ID
Deletes the specified FCIP circuit.
switch:admin>portcfg fciptunnel 1/12 create 20.10.12.34 20.09.14.57 10000
Operation succeeded
switch:admin>portcfg fcipcircuit 1/12 create 1 20.10.12.35 20.09.14.60 10000
Operation succeeded
switch:admin> portshow fcipcircuit 1/12 1
-------------------------------------------
Circuit ID: 1/12.1
Circuit Num: 1
Admin Status: Enabled
Oper Status: In Progress
Remote IP: 20.10.12.35
Local IP: 20.09.14.60
Metric: 0
Min Comm Rt: 10000
Max Comm Rt: 10000
SACK: On
Min Retrans Time: 100
Max Retransmits: 8
Keepalive Timeout: 5000
Path MTU Disc: 0
VLAN ID: (Not Configured)
L2CoS: (VLAN Not Configured)
DSCP: F: 0 H:
Flags: 0x00000000
0 M: 0 L: 0
Fabric OS Command Reference
53-1001764-02