Hasyncstop - Brocade Communications Systems 8 Command Reference Manual

2

haSyncStop

haSyncStop
Disables High Availability state synchronization.
Synopsis hasyncstop
Description Use this command to temporarily disable High Availability (HA) synchronization.
After issuing hasyncStop, the switch does not go back to sync start unless you reboot the active CP,
or reboot the standby CP, or issue hasyncStart. The time it takes for the HA sync to complete
depends on the system configuration. The HA sync timeout is set to 10 minutes.
Notes Disabling HA synchronization may cause failover to be disruptive.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands none
Examples To disable the HA state synchronizing process:
See Also haFailover, haShow, haSyncStart
392
switch:admin> hasyncstop
Fabric OS Command Reference
53-1001764-02