Brocade Communications Systems 8 Command Reference Manual page 679

-i mode
Examples To set the fabric ID of port 2/1 to 5 and the port ID format to core:
To configure port 2/0 to be an EX_Port and set the fabric ID to 4:
To disable fabric parameter negotiation on port 2/0 of an EX_Port:
To enable IDID on port 2:
To display EX_Port settings configured for Mi10K connectivity:
See Also portCfgVEXPort, portDisable, portEnable, portShow, portCfgDefault, fcrbCastConfig
Fabric OS Command Reference
53-1001764-02
an error message is posted, and the command fails. Valid values are as
follows:
0 Brocade Native mode.
1 McDATA Open Fabric mode.
2 McDATA Fabric mode.
3 MCDATA fabric legacy mode.
Note that this mapping between mode values and modes is NOT the same as
the mapping used when setting interoperability modes with the interopMode,
command.
Enables or disables Insistent Domain Id (IDID) for the specified EX_Port.
Specify 1 to enable IDID, specify 2 to disable IDID. This command must be
issued from a McDATA edge switch attached to a single or dual FCR
configuration.
switch:admin> portcfgexport 2/1 -f 5 -p 1
switch:admin> portcfgexport 2/0 -a 1 -f 4
switch:admin> portcfgexport 2/0 -t 2
switch:admin>portcfgexport 2 –i 1
switch:admin> portcfgexport 10
Port 10 info
Admin:
State:
Pid format:
Operate mode:
Domain Id mode:
Insistent Domain ID Mode:
Front WWN:
Fabric Parameters:
R_A_TOV:
E_D_TOV:
Authentication Type: None
DH Group: N/A
Hash Algorithm: N/A
Edge fabric's primary wwn: N/A
Edge fabric's version stamp: N/A
enabled
OK
Not Applicable
Open
239 Mode
enabled
50:00:51:e3:76:0e:4e:46
Auto Negotiate
Not Applicable
Not Applicable
2
portCfgEXPort
647