Brocade Communications Systems 8 Command Reference Manual page 783

Function Port display commands supported only on the Brocade 7800/FX8-24 and on the Brocade
7500/7500E/FR4-18i platforms
Synopsis portshow option [slot/]ge_port [optional_args]
Description Use this command to display FCIP-related configuration parameters on the Brocade 7800/FX8-24
and on the Brocade 7500/7500E/FR4-18i platforms. The parameters displayed by this command
are set with the portCfg command. The following displays are supported with this command:
•
•
•
•
Note Beginning with the Fabric OS v6.4.0 release, IPv6 addresses are supported on the Brocade 7800
and FX8-24 platforms. On the Brocade 7500/7500E and FR4-18i, IPv6 addresses are supported
on switches running Fabric OS v.6.0 or later.
Operands This command has the following operands:
slot
ge_port
ipif
iproute
arp
vlantag
Fabric OS Command Reference
53-1001764-02
portshow ipif - Displays the local IP interfaces.
portshow iproute - Displays static routes on the IP interface.
portshow arp - Displays the content of the address resolution protocol (ARP) table.
portshow vlantag - Displays the IP interface VLAN configuration.
For bladed systems only, specifies the slot number of the port to be displayed,
followed by a slash (/).
Specifies the number of the GbE port to be displayed relative to the slot
number. The GbE ports are numbered ge0 - ge9 on the Brocade FX8-24 blade
and ge0 - ge5 on the Brocade 7800 switch. The 10GbE ports on the Brocade
FX8-24 blade are numbered xge0 and xge1. The GbE ports on the Brocade
7500/7500E and FR4-18i are numbered ge0 and ge1. Use the switchShow
command for a listing of valid ports.
Displays the IP interface ID, IP address, netmask, and MTU for IPv4
addresses. Displays the prefix instead of the netmask for IPv6 addresses.
Flags are explained in the command output (refer to the example below).
Displays the IP address, netmask, gateway, metrics, and flags. Displays the
prefix instead of the netmask for IPv6 addresses. A status flag for the IP
routes indicates if a route is used for the management interfaces. A route
definition that uses one of the internal interfaces has the words "Interface
Management" printed at the end of the line.
Displays the address resolution protocol (ARP) table. On the 7800/FX8-24
platform you can display the content of the ARP table, but you cannot modify
its contents. On the 7500/7500E/FR4-18i you can add static ARP entries
using the portcfg arp command.
-lmac Displays the local MAC address. This operand is optional.
Displays the VLAN Tagging configuration. For each entry, the output displays
the IP interface address, the destination IP address, the VLAN ID, the L2 CoS
priority, and a flag. This display includes tunnel- and IPIF-level configurations.
The following flags indicate the type of configuration:
Perm Permanent entry. Permanent entries are configured at the IP interface
level with the portCfg vlantag command.
2
portShow
751