Brocade Communications Systems 8 Command Reference Manual page 805

iscsi
mode
ficon
inbandmgmt
Fabric OS Command Reference
53-1001764-02
-credits Displays FC data path credit data.
-ipsec Displays IKE and IPSec policy information on IPSec-enabled tunnels. Security
policies are configured with the portCfg command.
-qosmap Displays the mapping table for VC to FCIP QoS.
-bstr Displays FCIP TCP Byte Stream statistics on Byte Stream-enabled tunnels.
-hist Displays the history of TCP connections.
-snapstart Resets TCP statistics. The collection of the statistics restarts when this
command is executed. It ends when the -snapshow option is executed.
-snapshow Displays the TCP statistics that were collected since startup or since the
statistics were reset with the -snapshow command.
Displays GbE port WWN and ISCSI Sessions.
Displays mode of GbE port as either "FCIP" or "not configured".
Displays FICON emulation configuration parameters.
The syntax for tportshow ficon is as follows:
portshow ficon [Slot/] ge_port all | tunnel_Id [arg] [parm] [-clear]
The following arguments are supported with ficon:
-globals Displays general FICON controls and statistics.
-images Displays discovered Images (FCUB).
-emul Displays emulated FDCBs.
-active Displays active FDCBs.
-epcb Displays Emulation Control Block (port specific).
-fhpb Displays FICON Host Path Block.
-fdpb adrs Displays FICON Device Path Block.
-fchb Displays FICON Channel Control Block.
-fcub Displays FICON Control Unit Control Block.
-fdcb adrs Displays FICON Device Control Block.
-mem adrs Displays memory in 256-byte increments: ! for next.
-pools Displays current data buffer pool counts.
-pmmr Displays PMMR pointers.
-fastw Displays the FastWrite queue.
-clear Clears post-display statistics; requires a preceding argument.
Displays the status of the inband management configuration and IP
addresses configured to enable inband management on the Brocade 7500
through GbE port interfaces. This command requires a port to be specified
and displays the IP addresses for that port. In addition the output shows
whether inband management is enabled or disabled. To display the routing
table, use the portshow iproute command.
2
portShow
773