Portcfgshow - Brocade Communications Systems 8 Command Reference Manual

2

portCfgShow

portCfgShow
Displays port configuration settings.
Synopsis portcfgshow
portcfgshow [slot/]port
portcfgshow -i [index1[-index2] [...] [-f]]
portcfgshow -slot slot1[-slot2] [...]
portcfgshow option [slot/][ge_port] [arguments] [optional_arguments]
Description Use this command to display the current configuration of a port. The behavior of this command is
platform-specific; output varies depending on port type and platform, and not all options are
supported on all platforms.
"Non-GbE port displays"
When used without operands, this command displays port configuration settings for all ports on a
switch, except Gigabit Ethernet (GbE) ports.
"Displays supported only on the Brocade 7800 /FX8-24 and on the Brocade 7500/7500E/FR4-18i
platforms"
Use this command with optional arguments to display the following parameters configured for a
GbE port on the Brocade 7800/FX8-24 and on the Brocade 7500/7500E/FR4-18i platforms.
•
•
•
•
•
"Displays supported only on the Brocade 7500/7500E/FR4-18i platforms"
•
•
Non-GbE port displays
The following information is displayed when the command is issued for all ports, for a single port, or
for one or more port ranges specified by their port index numbers or slot numbers:
Area Number
Speed
Fill Word
674
IP interfaces on the GbE port
Static routes on the IP interfaces
Address resolution protocol (ARP) entries
VLAN tag configuration
Fibre Channel over IP (FCIP) tunnel configuration settings
-
IPSec configuration
-
QoS mappings (Brocade 7500/7500E/FR4-18i only)
Port mode information
Inband Management IP addresses and routes (Brocade 7500 only)
Displays the port area number. This field is displayed only when portCfgShow
is executed for a single port.
Displays Auto for auto speed negotiation mode, or a specific speed of 1, 2, 4,
or 8 Gbps. This value is set by the portCfgSpeed command.
Displays one of the following numeric values: 0(Idle-Idle), 1(arbff-arbff),
2(Idle-arbff), or 3(A-A then SW I-A).This parameter is set by the portcfgFillword
command.
Fabric OS Command Reference
53-1001764-02