Supportshowcfgenable - Brocade Communications Systems 8 Command Reference Manual

supportShowCfgEnable

Enables a group of commands to be displayed under the supportShow command.
Synopsis supportshowcfgenable os | exception | port | fabric | services | security | network | portlog |
system | extend | filter | perfmon | ficon | iswitch | asic_db |ag | dce_hsl |crypto | fcip
Description Use this command to enable a group of commands to be displayed under the supportShow
command. Use the supportShowCfgDisable command to disable groups of commands.
The FCIP commands are supported only on the Brocade 7800/FX8-24 and 7500/7500E/FR4-18i
platforms and cannot be configured to collect data on unsupported platforms.
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operands:
os
exception
port
fabric
services
security
network
portlog
system
extend
filter
perfmon
ficon
iswitch
asic_db
iscsi
ag
dce_hsl
crypto
fcip
Fabric OS Command Reference
53-1001764-02
Enables the OS group commands.
Enables the exception group commands.
Enables the port group commands.
Enables the fabric group commands.
Enables the service group commands.
Enables the security group commands.
Enables the network group commands.
Enables the portlog group commands.
Enables the system group commands.
Enables the extend group commands.
Enables the filter group commands.
Enables the Performance Monitor group commands.
Enables the FICON group commands.
Enables the FC Router group commands.
Enables the ASIC DB group commands.
Enables the iSCSI group commands.
Enables the Access Gateway group commands.
Disables the DCE group commands
Enables the encryption group commands.
Enables the FCIP group commands. Supported only on the Brocade
7800/FX8-24 and 500/7500E/FR4-18i.
supportShowCfgEnable
2
917