Brocade Communications Systems 8 Command Reference Manual page 726

2
portCmd
--traceroute
694
-t ttl Specifies the time to live. Valid values are 1 to 255. The default is 100. This
operand is optional.
-w wait_time Specifies the time to wait for the response of each ping request in
milliseconds. The default is 5000 ms and the maximum wait time is 9000 ms
(9 seconds). This operand is optional.
-z size Specifies the default packet size to a fixed size in bytes. The default is 64
bytes. In an IPv4 environment, the ICMP/IP header occupies 28 bytes. In an
IPv6 environment it occupies 48 bytes. The total size, including ICMP/IP
headers (28 or 48 bytes without IP options) cannot be greater than the IP
MTU configured on the interface. This operand is optional.
-v vlan_id Specifies the VLAN ID. Values must be in the range of 1 to 4094. There is no
default value. Note that a VLAN tag entry must exist on the local and remote
sides prior to issuing the -v option. A VLAN Tag table entry is dynamically
maintained by the ipperf application. See the portCfg help page for details on
creating a VLAN tag table.
-c L2 Class-of-Service
Specifies Class of Service/Priority, as defined by IEEE 802.1p. Values
must be in the range between 0 and 7. The default is 0. This operand is
optional with the -v option.
Traces the IP router hops used to reach the host dst_ip from one of the
source IP interfaces on the GbE port. Valid arguments include:
-s src_ip Specifies the local IP address to use for sourcing the probe packets. IPv6
addresses are supported.
-d dst_ip Specifies the destination IP address to which to probe the IP router path. IPv6
addresses are supported.
-h max_hops Specifies the maximum hop limit used in the outgoing probe packets. The
default value is 30 hops. This operand is optional.
-f first_ttl Specifies the starting point for the "time to live" parameter. The default is 1.
The command skips processing for those intermediate gateways that are less
than the first_ttl hops. This operand is optional.
-q service_type Specifies the type of service in the traceroute request. The default is 0 and
service_type must be an integer from 0 to 255. This operand is optional.
-w wait_time Sets the time, in milliseconds, to wait for a response to a probe. The default is
5000 milliseconds. The maximum wait time is 9000 milliseconds (9
seconds). This operand is optional.
-z size Specifies the size, in bytes, of the trace route packet to use. The default is 64
bytes. In an IPv4 environment, the ICMP/IP header occupies 28 bytes. In an
IPv6 environment, it occupies 48 bytes. The total size, including ICMP/IP
headers (28 or 48 bytes without IP options), cannot be greater than the IP
MTU configured on the interface. This operand is optional.
-v vlan_id Specifies the VLAN ID. Values must be in the range of 1 and 4094. There is
no default value. Note that a VLAN tag entry must exist on the local and
remote sides prior to issuing the -v option. A VLAN Tag table entry is
dynamically maintained by the ipperf application. See the portCfg help page
for details on creating a VLAN tag table.
Fabric OS Command Reference
53-1001764-02