Installation And Configuration - Nortel 1110 Fundamentals

36 Nortel IP Phone 2001
For more information, and for information about previous versions of the IP
Phone, contact your Nortel representative.
Installation and configuration
The following sections provide a step-by-step guide to install and configure
the IP Phone 2001:
•
•
•
•
•
Before you begin
Before installing the IP Phone 2001, complete the following pre-installation
checklist:
•
•
•
•
First-time installation
You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server
Installation and Commissioning (NN43001-312) and IP Line Fundamentals
(NN43100-500).
Copyright © 2003–2007, Nortel Networks
.
"Before you begin" (page 36)
"First-time installation" (page 36)
"Configuring the IP Phone 2001" (page 37)
"Startup sequence" (page 39)
"Installing the IP Phone 2001" (page 39)
Ensure one IP Phone 2001 boxed package exists for each IP Phone
2001 you install. The package contains:
— IP Phone 2001
— handset
— handset cord
— 2.1 m (7-ft) CAT5 Ethernet cable
— Getting Started Card
Ensure one Software License exists for each IP Phone 2001 you install.
Ensure the host Call Server is equipped with a Signaling Server that
runs the Line Terminal Proxy Server (LTPS) application.
If an AC power adapter is required, ensure you use the correct AC power
transformer. The voltage rating of the transformer must match the wall
outlet voltage. See Table 3 "IP Phone 2001 components list" (page
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
35).