Parameter Info; 15-92 Defined Parameters; Default Value - Danfoss VLT FC 102 Programming Manual

Programming Guide | VLT® HVAC Drive FC 102
Enter the preset fan running hours counter, see parameter 15-80 Fan Running Hours. This parameter cannot be selected via the serial
port RS485.
15-87 kWh Counter Hires

Default value:

0 kWh
Setup: All setups
Data type: Uint32
Register the power consumption of the motor as an average value over 1 hour. Reset the counter in parameter 15-06 Reset kWh Counter.
The decimal places are reset at power-up.
6.17.14

15-9* Parameter Info

15-92 Defined Parameters

Default value: 0
Setup:
All setups
Data type: Uint16
View a list of all defined parameters in the drive. The list ends with 0.
15-93 Modified Parameters
Default value: 0
Setup:
All setups
Data type: Uint16
View a list of the parameters that have been changed from their default setting. The list ends with 0. Changes may not be visible until up
to 30 s after implementation.
15-94 Extended Version
Default value: Size related
Setup:
All setups
Data type: VisStr[65]
View a list of SW build IDs in the drive. In a service case, Hotline can ask for SW build IDs.
15-98 Drive Identification
Default value: 0
Setup:
All setups
Data type: VisStr[40]
This parameter contains data used by the VLT® Motion Control Tool MCT 10.
15-99 Parameter Metadata
Default value:
0
© 2024.10
Parameter type:
Conversion index:
Change during operation:
Parameter typa:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
AU430028034214en-001901 / 130R0310 |
Parameter Descriptions
Range, 0 - 2147483647 kWh
75
False
Range, 0 - 9999, Array [2000]
0
False
Range, 0 - 9999, Array [1000]
0
False
Range, 0 - 65, Array [10]
0
True
Range, 0 - 40
0
False
Range, 0 - 9999, Array [30]
407