Danfoss VLT FC 102 Programming Manual page 52

Programming Guide | VLT® HVAC Drive FC 102
Option Name
[0] RPM
[1]* Hz
0-03 Regional Settings
Default value: –
Setup: 2 setups
Data type: Uint8
This parameter cannot be adjusted while the motor is running.
Option Name
[0] International
[1] North America
0-04 Operating State at Power-up (Hand)
Default value: [0] Resume
Setup: All setups
Data type: Uint8
Select the operating mode upon reconnection of the drive to mains voltage after power-down in hand-on mode.
Option Name
[0]* Resume
[1] Forced stop, ref=old
0-05 Local Mode Unit
Default value: [0] As motor speed
Setup: 2 setups
Data Type: Uint8
52 | © 2024.10
Description
Select to show motor speed variables and parameters using
motor speed (RPM).
Select to show motor speed variables and parameters using
output frequency (Hz).
Parameter type:
Conversion index:
Change during operation:
NOTICE
Description
Activate parameter 1-20 Motor Power [kW] for setting the motor
power in kW and set the default value of parameter 1-23 Motor
Frequency to 50 Hz.
Activate parameter 1-20 Motor Power [kW] for setting the motor
power in kW and set the default value of parameter 1-23 Motor
Frequency to 60 Hz.
Parameter type:
Conversion index:
Change during operation:
Description
Restart the drive, maintaining the start/stop settings (applied by
[Hand On]/[Off ]) selected before the power-down of the drive.
Restart the drive with a saved local reference after mains voltage
reappears and after pressing [Hand On].
Parameter type:
Conversion index:
Change during operation:
Parameter Descriptions
Option
–
False
Option
–
True
Option
–
False
AU430028034214en-001901 / 130R0310