Danfoss VLT FC 102 Programming Manual page 598

Programming Guide | VLT® HVAC Drive FC 102
31-67 Nominal SFP History
Default value: Size related
Setup: All setups
Data type: TimeOfDay
Shows the date and time of the last nominal capture. It is required to enter the date and time when the nominal SFP trigger is off.
31-68 SFP Threshold W1
Default value: 0%
Setup:
All setups
Data type: Uint16
When the actual current consumption crosses the W1 % threshold level over the SFP baseline, the drive generates a high W1 energy
consumption warning,.
31-69 SFP Threshold W2
Default value: 0%
Setup: All setups
Data type: Uint16
When the actual current consumption crosses the W2 % threshold level over the SFP baseline, the drive generates a high W2 energy
consumption warning.
6.28.8 31-7* Energy Cost Filter
Based on the SFP energy monitoring, the drive calculates an optimal time for replacing the filters. The actual additional energy
consumption versus the cost of replacing the filter is also considered in the calculation.
31-70 Filter Replacement Cost
Default value: 1
Setup:
All setups
Data type: Uint32
Enter the expected cost for replacing the filter. Consider if it is beneficial to replace more filters at the same time.
31-71 Cost Per KWH Energy
Default value: 1
Setup:
All setups
Data type: Uint32
Enter the actual energy cost of a kWh.
31-72 Differential Energy Cost
Default value:
1
598 | © 2024.10
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Parameter Descriptions
Range, 0 - 0
0
True
Range, 0 - 9999%
0
True
Range, 0 - 9999%
0
True
Range, 0 - 99999.99
-2
True
Range, 0 - 999999.99
-2
True
Range, 0 - 999999.99
AU430028034214en-001901 / 130R0310