Parameter Info; Parameter Group 16-** Data Readouts; General Status - Danfoss VLT AutomationDrive EZ FC 321 Programming Manual

VLT® AutomationDrive EZ FC 321
Programming Guide
Parameter 15-89 Configuration Change Counter
Table 573: Parameter 15-89 Configuration Change Counter
15-89 Configuration Change Counter
Default Value: 0
Conversion Index: 0
This parameter cannot be adjusted while the motor is running.

4.15.13 15-9* Parameter Info

Parameter 15-92 Defined Parameters
Table 574: Parameter 15-92 Defined Parameters
15-92 Defined Parameters
Default Value: 0
Conversion Index: 0
View a list of all defined parameters in the drive. The list ends with 0.
Parameter 15-98 Drive Identification
Table 575: Parameter 15-98 Drive Identification
15-98 Drive Identification
Default Value: 0
Conversion Index: 0
This parameter contains data used by the VLT® Motion Control Tool MCT 10.
Parameter 15-99 Parameter Metadata
Table 576: Parameter 15-99 Parameter Metadata
15-99 Parameter Metadata
Default Value: 0
Conversion Index: 0
This parameter contains data used by the VLT® Motion Control Tool MCT 10.

4.16 Parameter Group 16-** Data Readouts

4.16.1 16-0* General Status

Parameter 16-00 Control Word
Table 577: Parameter 16-00 Control Word
16-00 Control Word
Default Value: 0
Conversion Index: 0
Danfoss A/S © 2021.08
Parameter Type: Range, 0 - 65535
Data Type: Uint16
N O T I C E
Parameter Type: Range, 0 - 9999, Array [1000]
Data Type: Uint16
Parameter Type: Range, 0 - 40
Data Type: VisStr[40]
Parameter Type: Range, 0 - 9999, Array [35]
Data Type: Uint16
Parameter Type: Range, 0 - 65535
Data Type: V2
Parameter Descriptions
Setup: All set-ups
Change during operation: False
Setup: All set-ups
Change during operation: False
Setup: All set-ups
Change during operation: False
Setup: All set-ups
Change during operation: False
Setup: All set-ups
Change during operation: False
AU373327181955en-000101 / 130R1208 | 301