Danfoss VLT FC 102 Programming Manual page 78

Programming Guide | VLT® HVAC Drive FC 102
Data type: TimeOfDay
This parameter stores the last 5 drive power-off timestamps. Index [0] is the latest power-off time, and index [4] is the oldest.
0-76 DST/Summertime Start
Default value:
Size related
Setup: 1 setup
Data type:
TimeOfDay
Sets the date and time when DST/summer time starts. The date is programmed in the format selected in parameter 0-71 Date Format.
0-77 DST/Summertime End
Default value: Size related
Setup: 1 setup
Change during True
operation:
Sets the date and time when DST/summer time ends. The date is programmed in the format selected in parameter 0-71 Date Format.
0-79 Clock Fault
Default value: –
Setup: 1 setup
Data type: Uint8
Enables or disables the clock warning when the clock has not been set, or has been reset due to a power-down and no back-up is
installed. If VLT® Analog I/O Option MCB 109 is installed, [1] Enabled is default.
Option Name
[0] Disabled
[1] Enabled
0-81 Working Days
Default value: Depending on the selected array element.
Setup: 1 setup
Data type: Uint8
Array with 7 elements [0]–[6] shown below the parameter number in the display. Press [OK] and step between elements with [▲] and
[▼]. Set for each weekday if it is a working day or a non-working day. The first element of the array is Monday. The working days are used
for timed actions.
78 | © 2024.10
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Data type:
Parameter type:
Conversion index:
Change during operation:
Description
Parameter type:
Conversion index:
Change during operation:
Parameter Descriptions
True
Range, 0 - 0
0
True
Range, 0 - 0
TimeOfDay
Option
-1
True
Option, Array [7]
–
True
AU430028034214en-001901 / 130R0310