Varia; Parameter Group 1-** Load And Motor; General Settings - Danfoss VLT FC 102 Programming Manual

Programming Guide | VLT® HVAC Drive FC 102
Shows the summer time end for fieldbus.
0-88 Clock Restore at Powerup
Default value: [0] Disabled
Setup: 1 setup
Data type: Uint8
Option Name
[0]* Disabled
[1] Enabled
0-89 Date and Time Readout
Default value: 0
Setup: All setups
Data type:
VisStr[25]
Shows the current date and time. The date and time is updated continuously. The clock does not begin counting until a setting different
from default has been made in parameter 0-70 Date and Time.

0-9* Varia

6.2.10
0-95 Warning LED Blinking
Default value: [0] Constant on
Setup: 1 setup
Data type: Uint8
Option Name
[0]* Constant on
[1] Blinking

Parameter Group 1-** Load and Motor

6.3

1-0* General Settings

6.3.1
Define whether the drive operates in open loop or closed loop.
1-00 Configuration Mode
Default value: –
80 | © 2024.10
Parameter type:
Conversion index:
Change during operation:
Description
Restoring the time at power-up is disabled.
Restoring the time at power-up is enabled. Date and time will
be stored at power down. When the drive is powered up, the
previous time is used. As the previous time is incorrect, warning
98, Clock Fault is issued and stays active until date and time are
set again.
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Description
Use [1] Blinking to identify a drive when many drives are
mounted together.
Parameter type:
Parameter Descriptions
Option
–
True
Range, 0 - 25
0
True
Option
–
True
Option
AU430028034214en-001901 / 130R0310