Product Code - Danfoss VLT FC 102 Programming Manual

Programming Guide | VLT® HVAC Drive FC 102
This is an array parameter with 16 elements, 1 element for each bit in range 0–15. Each of the bits can be configured to any of the
following options.
Option Name
[0] None
[1]* Profile default
[2] CTW valid, active low
[7] External interlock
[10] Bit 10 = 0 > CTW timeout
[15] Relay 1
[16] Relay 2
[22] Digital out 27
[23] Digital out 29
[24] Digital out X30/6
[25] Digital out X30/7
[33] Bit 10 = 0 > CTW TO always
[66] Sleep mode
[78] Reset preventive maintenance word
[189] Fire mode
[190] Fire mode ref bit 0
[191] Fire mode ref bit 1
[192] Fire mode ref bit 2
[193] Fire mode setup bit 0
[194] Fire mode setup bit 1
[195] Test fire mode
[235] Setup bit 0
[236] Setup bit 1

8-19 Product Code

Default value:
Size related
Setup: 1 setup
Data type: Uint32
Select 0 to read out the actual fieldbus product code according to the mounted fieldbus option. Select 1 to read out the actual vendor ID.
© 2024.10
Description
The drive ignores the information in this bit.
Dependent on the profile set in parameter 8-10 Control Profile.
If set to 1, the drive ignores the remaining bits of the control
word.
Control relay 1.
Control relay 1.
Enables a choice between 1 of the 8 preset references.
Enables a choice between 1 of the 8 preset references.
Enables a choice between 1 of the 8 preset references.
Fire mode is activated in a special test mode where the drive
stops on all alarms.
Parameter type:
Conversion index:
Change during operation:
AU430028034214en-001901 / 130R0310 |
Parameter Descriptions
Range, 0 - 2147483647, Array
[2]
0
True
229