Danfoss VLT FC 102 Programming Manual page 411

Programming Guide | VLT® HVAC Drive FC 102
View the calculated thermal load on the motor. The cutout limit is 100%. The basis for calculation is the ETR function selected in
parameter 1-90 Motor Thermal Protection.
16-19 Thermistor Sensor Temperature
Default value: 0 °C
Setup: All setups
Data type: Int16
Returning the actual temperature on KTY sensor built into the motor. See parameter group 1-9* Motor Temperature.
16-20 Motor Angle
Default value: 0
Setup:
All setups
Data type: Uint16
View the current encoder/resolver angle offset relative to the index position. The value range of 0–65535 corresponds to 0–2xpi (radian).
16-22 Torque [%]
Default value: 0%
Setup: All setups
Data type: Int16
The value shown is the torque in percent of nominal torque, with sign, applied to the motor shaft.
16-23 Motor Shaft Power [kW]
Default value:
0 kW
Setup: All setups
Data type:
Int32
Readout of the mechanical power applied to the motor shaft. The base unit is in W.
16-24 Calibrated Stator Resistance
Default value: 0.0000 Ohm
Setup: All setups
Data type:
Uint32
Shows the calibrated stator resistance.
16-26 Power Filtered [kW]
Default value: 0 kW
Setup:
All setups
Data type: Int32
© 2024.10
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
AU430028034214en-001901 / 130R0310 |
Parameter Descriptions
Range, 0 - 0 °C
100
False
Range, 0 - 65535
0
True
Range, -200 - 200%
0
False
Range, 0 - 10000 kW
1
True
Range, 0.0000 - 100.0000 Ohm
-4
True
Range, 0 - 10000 kW
0
False
411