Parameter Group 15-** Drive Information; Operating Data; Setup: All Setups; Data Type: Uint16 - Danfoss VLT FC 102 Programming Manual

Programming Guide | VLT® HVAC Drive FC 102
VLT® Motion Control Tool MCT 10 has the element numbers listed in the column ID. Use this table with MCT 10 to get information about
specific fault levels.

Parameter Group 15-** Drive Information

6.17

15-0* Operating Data

6.17.1
15-00 Operating Hours
Default value: 0 h
Setup: All setups
Data type: Uint32
View for how many hours the drive has run. The value is saved when the drive is turned off.
15-01 Running Hours
Default value:
0 h
Setup: All setups
Data type:
Uint32
View how many hours the motor has run. Reset the counter in parameter 15-07 Reset Running Hours Counter. The value is saved when
the drive is turned off.
15-02 kWh Counter
Default value: 0 kWh
Setup:
All setups
Data type: Uint32
Register the power consumption of the motor as an average value over 1 hour. Reset the counter in parameter 15-06 Reset kWh Counter.
15-03 Power Up's
Default value:
0
Setup: All setups
Data type: Uint32
View the number of times the drive has been powered up.
15-04 Over Temp's
Default value:
0
Setup: All setups
Data type:
Uint16
View the number of drive temperature faults.
© 2024.10
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
AU430028034214en-001901 / 130R0310 |
Parameter Descriptions
Range, 0 - 2147483647 h
74
False
Range, 0 - 2147483647 h
74
False
Range, 0 - 2147483647 kWh
75
False
Range, 0 - 2147483647
0
False
Range, 0 - 65535
0
False
385