Parameter Access - Danfoss VLT FC 102 Programming Manual

Programming Guide | VLT® HVAC Drive FC 102
Sets up the filter mask for PCD 3. When operating in COS (change-of-state), it is possible to filter out bits in PCD 3 that should not be sent
if they change.
10-23 COS Filter 4
Default value: 0
Setup: All setups
Data type: Uint16
Sets up the filter mask for PCD 4. When operating in COS (change-of-state), it is possible to filter out bits in PCD 4 that should not be sent
if they change.
6.12.4

10-3* Parameter Access

10-30 Array Index
Default value: 0
Setup:
2 setups
Data type: Uint8
View array parameters. This parameter is only valid when a VLT® DeviceNet MCA 104 is installed.
10-31 Store Data Value
Default value: [0] Off
Setup:
All setups
Data type: Uint8
This parameter is used to activate a function that stores all parameter values in the non-volatile memory, this retaining changed
parameter values at power-down.
Option Name
[0]* Off
[1] Store edit setup
[2] Store all setups
10-32 Devicenet Revision
Default value: 0
Setup:
All setups
Data type: Uint16
The DeviceNet revision number. This parameter is used for EDS file creation.
268 | © 2024.10
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Description
Deactivates the non-volatile storage function.
Stores all parameter values from the active setups in the non-
volatile memory. The selection returns to [0] Off when all values
have been stored.
Stores all parameter values for all setups in the non-volatile
memory. The selection returns to [0] Off when all parameter
values have been stored.
Parameter type:
Conversion index:
Change during operation:
Parameter Descriptions
Range, 0 - 65535
0
False
Range, 0 - 255
0
True
Option
–
True
Range, 0 - 65535, Array 2
0
True
AU430028034214en-001901 / 130R0310