Danfoss VLT FC 102 Programming Manual page 223

Programming Guide | VLT® HVAC Drive FC 102
Option Name
[20] N2 Override release
[27] Forced stop and trip
[30] Warning only
8-05 End-of-Timeout Function
Default value: [1] Resume set-up
Setup:
1 setup
Data type: Uint8
Select the action after receiving a valid control word following a timeout. This parameter is active only when parameter 8-04 Control
Word Timeout Function is set to:
[7] Setup 1
l
[8] Setup 2
l
[9] Setup 3
l
[10] Setup 4
l
Option Name
[0] Hold set-up
[1]* Resume setup
8-06 Reset Control Word Timeout
Default value: [0] Do not reset
Setup: All setups
Data type: Uint8
This parameter is active only when [0] Hold set-up has been selected in parameter 8-05 End-of-Timeout Function.
Option Name
[0]* Do not reset
[1] Do reset
8-07 Diagnosis Trigger
Default value: [0] Disable
© 2024.10
Description
Parameter type:
Conversion index:
Change during operation:
Description
Retains the setup selected in parameter 8-04 Control Word
Timeout Function and shows a warning until parameter 8-06
Reset Control Word Timeout toggles. Then the drive resumes its
original setup.
Resumes the setup that was active before the timeout.
Parameter type:
Conversion index:
Change during operation:
Description
Retains the setup specified in parameter 8-04 Control Word
Timeout Function, following a control word timeout.
Restores the drive to the original setup following a control word
timeout. The drive resets and then immediately reverts to the [0]
Do not reset setting.
Parameter type:
AU430028034214en-001901 / 130R0310 |
Parameter Descriptions
Option
–
True
Option
–
True
Option
223