Danfoss VLT FC 102 Programming Manual page 627

Programming Guide | VLT® HVAC Drive FC 102
Option Name
[107] Speed 0-HighLim
[113] Ext. closed loop 1
[114] Ext. closed loop 2
[115] Ext. closed loop 3
[117] Shaft power
[121] Air pres- to flow
[139] Bus ctrl
[141] Bus ctrl t.o.
[186] Pressure sensor 4
36-51 Terminal X49/9 Digital Output
Default value: [0] No operation
Setup: All setups
Data type: Uint8
Select the function of terminal X49/7 as a digital output.
Option Name
[0]* No operation
[1] Control ready
[2] Drive ready
[3] Drive rdy/rem ctrl
[4] Standby/no warning
[5] Running
[6] Running/no warning
[8] Run on ref/no warn
[9] Alarm
[10] Alarm or warning
[11] At torque limit
© 2024.10
Description
Taken from parameter 3-03 Maximum Reference. 20 mA equals
the value in parameter 3-03 Maximum Reference.
0–100%, (0–10 V)
0–100%, (0–10 V)
0–100%, (0–10 V)
An output value set from fieldbus process data. The output works
independently of internal functions in the drive.
Parameter 4-54 Warning Reference Lowdefines the behavior of
the analog output in case of fieldbus timeout.
Parameter type:
Conversion index:
Change during operation:
Description
All digital and relay outputs are by default set to No Operation.
The control card is ready.
The drive is ready to operate. Mains and control supplies are OK.
The drive is ready for operation and is in auto-on mode.
The drive is ready for operation. No start or stop command is
given (start/disable). There are no warnings.
The motor is running, and shaft torque is present.
Output speed is higher than the speed set in parameter 1-81 Min
Speed for Function at Stop [RPM]. The motor runs and there are
no warnings.
The motor runs at reference speed. No warnings.
An alarm activates the output. No warnings.
An alarm or a warning activates the output.
The torque limit set in parameter 4-16 Torque Limit Motor Mode
or parameter 4-17 Torque Limit Generator Mode has been
exceeded.
AU430028034214en-001901 / 130R0310 |
Parameter Descriptions
Option
–
True
627