Ethernet Link Parameters - Danfoss VLT FC 102 Programming Manual

Programming Guide | VLT® HVAC Drive FC 102
Setup: 1 setup
Data type: OctStr[4]
IP addresses of the domain name servers. Can be automatically assigned when using DHCP.
12-07 Domain Name
Default value: 0
Setup:
1 setup
Data type: VisStr[48]
Domain name of the attached network. Can be automatically assigned when using DHCP network.
12-08 Host Name
Default value: 0
Setup: 1 setup
Data type: VisStr[48]
The display of the drive only shows the 1st 19 characters, but the remaining characters are stored in the drive.
Logical (given) name of the option.
12-09 Physical Address
Default value:
0
Setup: 1 setup
Data type:
VisStr[17]
This parameter is read-only. It shows the physical (MAC) address of the option.

12-1* Ethernet Link Parameters

6.14.2
12-10 Link Status
Default value: [0] No link
Setup: All setups
Data type: Uint8
This parameter is read-only. It shows the link status of the Ethernet ports. Index [0] is used for port 1, and index [1] is used for port 2. For
EtherCAT, index [0] is for the in-port, and index [1] is for the out-port.
Option Name
[0]* No link
[1] Link
© 2024.10
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
NOTICE
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Description
Parameter Descriptions
0
True
Range, 0 - 48
0
True
Range, 0 - 48
0
True
Range, 0 - 17
0
True
Option, Array [2]
–
True
AU430028034214en-001901 / 130R0310 | 273