Danfoss VLT FC 102 Programming Manual page 272

Programming Guide | VLT® HVAC Drive FC 102
12-01 IP Address
Default value: 0
Setup: 1 setup
Data type: OctStr[4]
Configure the IP address of the option. Read-only if parameter 12-00 IP Address Assignment is set to [1] DHCP, [2] BOOTP, or via DIP
switches.
12-02 Subnet Mask
Default value:
0
Setup: 1 setup
Data type:
OctStr[4]
Configure the IP subnet mask of the option. Read-only if parameter 12-00 IP Address Assignment is set to [1] DHCP or [2] BOOTP.
12-03 Default Gateway
Default value: 0
Setup: 1 setup
Data type: OctStr[4]
Configure the IP default gateway of the option. Read-only if parameter 12-00 IP Address Assignment set to [1] DHCP or [2] BOOTP. In a
non-routed network, this address is set to the IP address of the I/O device.
12-04 DHCP Server
Default value:
0
Setup: All setups
Data type:
OctStr[4]
A power cycle is necessary after setting the IP parameters manually.
This parameter is read-only. It shows the IP address of the found DHCP or BOOTP server.
12-05 Lease Expires
Default value: Size related
Setup:
All setups
Data type: TimeDifferenceWithDateIndication
This parameter is read-only. It shows the lease time for the current DHCP-assigned IP address.
12-06 Name Servers
Default value: 0
272 | © 2024.10
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
NOTICE
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Parameter Descriptions
Range, 0 - 4294967295
0
True
Range, 0 - 4294967295
0
True
Range, 0 - 4294967295
0
True
Range, 0 - 2147483647
0
True
Range, Size related
0
True
Range, 0 -4294967295, Array
[2]
AU430028034214en-001901 / 130R0310