Setting The Rfid Scanner Parameters; Setting The Desk Height Adjustment Parameters; Setting The Interface Parameters - Dürkopp Adler D867 e-con Service Instructions Manual

Important
The barcode must be composed of 3 to 32 bars. The 3-digit number of
the program (001 to 999) must be contained in the barcode.
Refer to the Appendix ( p. 245) for a few barcode examples that you
can use.
Information
The scanner also supports other types of barcodes. For a list of all supported
barcodes and information on how to configure them, refer to the  Operating
Instructions of the scanner manufacturer.

19.4.29 Setting the RFID scanner parameters

Icon
RFID

19.4.30 Setting the Desk height adjustment parameters

Icon

19.4.31 Setting the Interface parameters

The interfaces can be used for the scanner. The parameter is active if a
scanner is connected.
156
Menu items
RFID scanner
RFID
Menu items
Desk height adjustment enable
Desk height offset
If there is an obstacle below the sensor,
the distance between the obstacle and the
floor must be specified.
Only visible for Desk height
adjustment enable
Desk height
Only visible for Desk height
adjustment enable
Value range
• Value range
On/Off
Value range
• Value range
On/Off
• Value range
-60.0 - 80.00 [cm]
• Value range
000.0 - 140.0
Service Instructions D867 e-con - 00.0 - 08/2023
Programming