Table of Contents
Advertisement
5. Turn the pusher eccentric (2) such that the feed-dog and needle no
6. Tighten the pusher eccentric setscrews (1).
9.2.2 Setting the feed-dog height in the top dead center
The feed-dog reaches the maximum stroke height at the top dead center
when the position of the handwheel is 190°.
Correct setting
Handwheel in the 190° position:
Cover
• Tilt the upper section backwards
Figure 29: Setting the feed-dog height
Setting steps
1. Put the handwheel into the 190° position.
2. Loosen the setscrews (2) on the lever (1) at the left, above the hook.
3. Turn the lever (1) such that the upper edge of the feed-dog protrudes
4. Tighten the setscrews (2).
38
longer move when the stitch adjustment lever (3) is pressed.
WARNING
Risk of crushing
Switch off the sewing machine before checking and setting the
feed-dog height.
The upper edge of the feed-dog protrudes 0.8 mm above the throat
plate.
(
Section 4.4.1 Access to the machine bottom section, page 10)
1
(1) - Lever
0.8 mm above the throat plate.
Setting the feed-dog
(2) - Setscrews
Service manual H867 Version 00.0 - 08/2013
Advertisement
Table of Contents
