Fdt/Dtm With The Ethernet Controller 750-841; Figure 34: Wago-I/O-Pro Project With Integrated "Wagolibhart_0X.lib - WAGO 753-482 Manual

66 Commissioning
You can then access the HART commands directly in your project and
execute these locally from your "IEC 61131-3" application.
Figure 34: WAGO-I/O-PRO Project with Integrated "WagoLibHART_0x.lib" Library
More information about WAGO-I/O-PRO CAA
Detailed descriptions of the functions and use of the WAGO-I/O-PRO CAA IEC
61131-3 programming tool are available in the WAGO-I/O-PRO CAA (759-333)
manual on the Internet at: www.wago.com
9.2

FDT/DTM with the ETHERNET Controller 750-841

In the default mode "2AI + 6-byte mailbox", when the HART I/O module is
connected to a WAGO ETHERNET TCP/IP Controller 750-841, it is also possible
to carry out HART communication by means of the FDT/DTM frame application
"WAGOframe".
Consider the maximum number of modules!
Because of the process data capacity of the HART I/O module, please be sure to
take into account the corresponding maximum number of modules that can be
connected when using a WAGO ETHERNET Controller 750-841. You can find
this number in the table "Compatibility List".
Manual
Version 1.2.0
WAGO I/O System 750
753-482 2AI 4-20mA 12 Bit S.E. HART