Scsi Connections - ADIC Scalar 100 User Manual

SCSI Connections

The tape library is a SCSI target device that can be connected to either a SCSI-2 Low Voltage Differential
or High Voltage Differential SCSI bus. You can set the SCSI device using the switch located on the Library
Controller. Both ends of the bus must be terminated. A terminator is shipped with each library.
The library requires SCSI-2 P cables with 68-pin D-connectors. (When attaching to a 1-byte host, a 1-byte
to 2-byte interposer is required.) Although the library can be attached to a wide SCSI bus, it is not a wide
SCSI device and its SCSI ID must be in the range of 0 to 7. The default SCSI ID for the library is 0.
The library can also be connected to a Storage Area Network (SAN) via an optional Storage Networking
Controller (SNC), where the SNC converts either Fibre Channel protocol or Gigabit Ethernet (GbE) protocol
to parallel SCSI protocol.
22 Description