H3C S6812 Series Command Reference Manual page 1866

Usage guidelines
If you configure the maximum total number smaller than the number of current online portal users on
the device, this command still takes effect. The online users are not affected by this command, but
the system forbids new portal users to log in.
This command sets the maximum number of online IPv4 and IPv6 portal users in all.
Make sure the total number of the maximum IPv4 and IPv6 portal users allowed on all interfaces
does not exceed the system-allowed maximum number. Otherwise, the exceeding portal users will
not be able to log in to the device.
Examples
# Set the maximum number of online portal users allowed in the system to 100.
<Sysname> system-view
[Sysname] portal max-user 100
Related commands
display portal user
portal { ipv4-max-user | ipv6-max-user }
portal nas-id-profile
Use portal nas-id-profile to specify a NAS-ID profile for an interface.
Use undo portal nas-id-profile to restore the default.
Syntax
portal nas-id-profile profile-name
undo portal nas-id-profile
Default
No NAS-ID profile is specified for an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
profile-name: Specifies the name of a NAS-ID profile, a case-insensitive string of 1 to 31 characters.
Usage guidelines
A NAS-ID profile defines the binding relationship between VLANs and NAS-IDs. To configure a
NAS-ID profile, use the aaa nas-id profile command.
If an interface is specified with a NAS-ID profile, the interface prefers to use the bindings defined in
the profile.
If no NAS-ID profile is specified for an interface or no matching binding is found in the specified
profile, the device uses the device name as the interface NAS-ID.
Examples
# Specify NAS-ID profile aaa for VLAN-interface 2.
<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] portal nas-id-profile aaa
52