H3C S6812 Series Command Reference Manual page 1606

group 1: Specifies WFQ group 1. Only WFQ group 1 is supported in the current software version.
byte-count: Allocates bandwidth to queues based on byte count.
weight: Allocates bandwidth to queues based on packet count.
schedule-value: Specifies a scheduling weight in the range of 1 to 15.
Usage guidelines
You must use the qos wfq command to enable WFQ before you configure this command.
Examples
# Enable byte-count WFQ on Ten-GigabitEthernet 1/0/1, and specify scheduling weight 10 for queue
0.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] qos wfq byte-count
[Sysname-Ten-GigabitEthernet1/0/1] qos wfq 0 group 1 byte-count 10
Related commands
display qos queue wfq interface
qos bandwidth queue
qos wfq
qos wfq group sp
Use qos wfq group sp to assign a queue to the SP group.
Use undo qos wfq group sp to remove a queue from the SP group.
Syntax
qos wfq queue-id group sp
undo qos wfq queue-id
Default
All queues on a WFQ-enabled interface are in WFQ group 1.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Parameters
queue-id: Specifies a queue by its ID. The value range for this argument is 0 to 7 or keywords in
Table 20.
Usage guidelines
This command is available only on a WFQ-enabled interface. Queues in the SP group are scheduled
with SP, instead of WFQ. The SP group has higher scheduling priority than the WFQ groups.
You must use the qos wfq command to enable WFQ before you configure this command.
Examples
# Enable WFQ on Ten-GigabitEthernet 1/0/1, and assign queue 0 to the SP group.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
55