H3C S6812 Series Command Reference Manual page 1908

snmp-agent trap enable port-security
Use snmp-agent trap enable port-security to enable SNMP notifications for port security.
Use undo snmp-agent trap enable port-security to disable SNMP notifications for port security.
Syntax
snmp-agent trap enable port-security [ address-learned | dot1x-failure | dot1x-logoff |
dot1x-logon | intrusion | mac-auth-failure | mac-auth-logoff | mac-auth-logon ] *
undo snmp-agent trap enable port-security [ address-learned | dot1x-failure | dot1x-logoff |
dot1x-logon | intrusion | mac-auth-failure | mac-auth-logoff | mac-auth-logon ] *
Default
All port security SNMP notifications are disabled.
Views
System view
Predefined user roles
network-admin
network-operator
Parameters
address-learned: Specifies notifications about MAC address learning.
dot1x-failure: Specifies notifications about 802.1X authentication failures.
dot1x-logoff: Specifies notifications about 802.1X user logoffs.
dot1x-logon: Specifies notifications about 802.1X authentication successes.
intrusion: Specifies notifications about illegal frame detection.
mac-auth-failure: Specifies notifications about MAC authentication failures.
mac-auth-logoff: Specifies notifications about MAC authentication user logoffs.
mac-auth-logon: Specifies notifications about MAC authentication successes.
Usage guidelines
To report critical port security events to an NMS, enable SNMP notifications for port security. For
port security event notifications to be sent correctly, you must also configure SNMP on the device.
For more information about SNMP configuration, see the network management and monitoring
configuration guide for the device.
If you do not specify a notification, this command enables all SNMP notifications for port security.
This command takes effect only when the intrusion protection feature is configured by using the
port-security intrusion-mode command.
Examples
# Enable SNMP notifications about MAC address learning.
<Sysname> system-view
[Sysname] snmp-agent trap enable port-security address-learned
Related commands
display port-security
port-security enable
20