H3C S6812 Series Command Reference Manual page 1825

Related commands
reset portal packet statistics
display portal rule
Use display portal rule to display portal packet filtering rules.
Syntax
display portal rule { all | dynamic | static } interface interface-type interface-number [ slot
slot-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
all: Displays all portal packet filtering rules, including dynamic and static portal packet filtering rules.
dynamic: Displays dynamic portal packet filtering rules, which are generated after users pass portal
authentication. These rules allow packets with specific source IP addresses to pass the interface.
static: Displays static portal packet filtering rules, which are generated after portal authentication is
enabled. The interface filters packets by these rules when portal authentication is enabled.
interface interface-type interface-number: Specifies an interface by its type and number.
slot slot-number: Specifies an IRF member device by its member ID. If you do not specify a member
device, this command displays portal packet filtering rules for all member devices.
Examples
# Display all portal packet filtering rules on VLAN-interface 100.
<Sysname> display portal rule all interface vlan-interface 100 slot 1
Slot 1:
IPv4 portal rules on Vlan-interface100:
Rule 1
Type
Action
Protocol
Status
Source:
IP
Mask
Port
MAC
Interface
VLAN
Destination:
IP
Mask
Port
: Static
: Permit
: Any
: Active
: 0.0.0.0
: 0.0.0.0
: Any
: 0000-0000-0000
: Vlan-interface100
: 100
: 192.168.0.111
: 255.255.255.255
: Any
11