H3C S6812 Series Command Reference Manual page 1880

Related commands
portal web-server
server-register
Use server-register to set the interval at which the device registers with a portal authentication
server.
Use undo server-register to restore the default.
Syntax
server-register [ interval interval-value ]
undo server-register
Default
The device does not register with a portal authentication server.
Views
Portal authentication server view
Predefined user roles
network-admin
Parameters
interval interval-value: Specifies the register interval in the range of 1 to 3600 seconds. The default
interval is 600 seconds.
Usage guidelines
This feature is typically used in scenarios where a NAT device exists between a portal authentication
server and an access device.
After this feature is enabled, the access device automatically sends register packets to the portal
authentication server. The register packet contains the access device name. After the server
receives the register packet, it records register information for the access device, including the
device name and the IP address and port number after NAT. The register information is used for
subsequent authentication information exchanges between the server and the access device. The
access device updates its register information on the server by sending register packets at regular
intervals.
Only CMCC portal authentication servers support this feature.
Examples
# Configure the device to register with the portal authentication server at an interval of 120 seconds.
<Sysname> system-view
[Sysname] portal server pts
[Sysname-portal-server-pts] server-register interval 120
Related commands
server-type
server-type
Use server-type to specify the type of a portal authentication server or portal Web server.
Use undo server-type to restore the default.
66