H3C S6812 Series Command Reference Manual page 1600

2
3
4
5
6
7
Table 19 Command output
Field
Interface
Output queue
Group
Weight
Byte count
qos wrr
Use qos wrr to enable WRR queuing on an interface.
Use undo qos wrr to restore the default.
Syntax
qos wrr { byte-count | weight }
undo qos wrr { byte-count | weight }
Default
Byte-count WRR queuing is used on an interface.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Parameters
byte-count: Allocates bandwidth to queues based on byte count.
weight: Allocates bandwidth to queues based on packet count.
Usage guidelines
You must use the qos wrr command to enable WRR queuing before you can configure WRR
queuing parameters for a queue on an interface.
Examples
# Enable weight-based WRR queuing on Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] qos wrr weight
# Enable byte-count WRR queuing on Ten-GigabitEthernet 1/0/1.
af2 1
af3 1
af4 1
ef 1
cs6 1
cs7 sp
Description
Interface type and interface number.
Type of the current output queue.
Number of the group a queue is assigned to. By default, all queues belong to
group 1.
Packet-based queue scheduling weight of a queue. N/A is displayed for a queue
that uses the SP scheduling algorithm.
Byte-based scheduling weight of a queue.
1
1
1
1
1
N/A
49