H3C S6812 Series Command Reference Manual page 1741

Parameters
accounting: Specifies the shared key for secure HWTACACS accounting communication.
authentication: Specifies the shared key for secure HWTACACS authentication communication.
authorization: Specifies the shared key for secure HWTACACS authorization communication.
cipher: Specifies the key in encrypted form.
simple: Specifies the key in plaintext form. For security purposes, the key specified in plaintext form
will be stored in encrypted form.
string: Specifies the key. This argument is case sensitive.
•
In non-FIPS mode, the encrypted form of the key is a string of 1 to 373 characters. The plaintext
form of the key is a string of 1 to 255 characters.
•
In FIPS mode, the encrypted form of the key is a string of 15 to 373 characters. The plaintext
form of the key is a string of 15 to 255 characters. The plaintext string must contain digits,
uppercase letters, lowercase letters, and special characters.
Usage guidelines
The shared keys configured on the device must match those configured on the HWTACACS servers.
Examples
# In HWTACACS scheme hwt1, set the shared key to 123456TESTauth&! in plaintext form for
secure HWTACACS authentication communication.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] key authentication simple 123456TESTauth&!
# Set the shared key to 123456TESTautr&! in plaintext form for secure HWTACACS authorization
communication.
[Sysname-hwtacacs-hwt1] key authorization simple 123456TESTautr&!
# Set the shared key to 123456TESTacct&! in plaintext form for secure HWTACACS accounting
communication.
[Sysname-hwtacacs-hwt1] key accounting simple 123456TESTacct&!
Related commands
display hwtacacs scheme
nas-ip (HWTACACS scheme view)
Use nas-ip to specify a source IP address for outgoing HWTACACS packets.
Use undo nas-ip to delete the source IP address of the specified type for outgoing HWTACACS
packets.
Syntax
nas-ip { ipv4-address | ipv6 ipv6-address }
undo nas-ip [ ipv6 ]
Default
The source IP address of an outgoing HWTACACS packet is that configured by using the hwtacacs
nas-ip command in system view.
If the hwtacacs nas-ip command is not configured, the source IP address is the primary IP address
of the outbound interface.
100