H3C S6812 Series Command Reference Manual page 1576

Field
Red packets
For the description of other fields, see
display qos policy interface
Use display qos policy interface to display the QoS policies applied to interfaces.
Syntax
display qos policy interface [ interface-type interface-number ] [ slot slot-number ] [ inbound |
outbound ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-type interface-number: Specifies an interface by its type and number.
slot slot-number: Specifies an IRF member device by its member ID. If you do not specify an IRF
member device, this command displays QoS policies on the master device. Only virtual interfaces
such as VLAN interfaces and aggregate interfaces support this option.
inbound: Displays the QoS policy applied to the incoming traffic of the specified interface.
outbound: Displays the QoS policy applied to the outgoing traffic of the specified interface.
Usage guidelines
If you do not specify a direction, this command displays the QoS policy applied to incoming traffic
and the QoS policy applied to outgoing traffic.
Examples
# Display the QoS policy applied to the incoming traffic of Ten-GigabitEthernet 1/0/1.
<Sysname> display qos policy interface ten-gigabitethernet 1/0/1 inbound
Interface: Ten-GigabitEthernet1/0/1
Direction: Inbound
Policy: 1
Classifier: 1
Matched : 0 (Packets) 0 (Bytes)
5-minute statistics:
Forwarded: 0/0 (pps/bps)
Dropped
Operator: AND
Rule(s) :
If-match acl 2000
Behavior: 1
Marking:
Remark dscp 3
Committed Access Rate:
Description
Statistics about red packets.
Table 1
: 0/0 (pps/bps)
and Table 4.
25