Removing And Installing Selector Lever Handle; Removing And Installing Selector Mechanism Cover - Audi A8 2003 Workshop Manual

6 - Cover plate
❑ Includes symbol insert
❑ Removing and installing
7 - Magnet for symbol illumination switch
8 - Magnet for tiptronic recognition switch
4.2 Removing and installing selector lever
handle
Removing
– Shift selector lever to position "D".
– Turn sleeve -1- in clockwise direction until you feel it engage.
Push sleeve downwards in this position.
– Pull off handle -2- from selector lever.
Installing
Installation is carried out in reverse sequence; note the following:
– Shift selector lever to position "D".
– Fit sleeve -1- onto selector lever.
– Press handle -2- onto selector lever as far as it will go.
• Installation position: Button points to driver.
– Keep turning sleeve in both directions and simultaneously
push it upwards until lugs on sleeve engage in slits on handle.
– Turn sleeve in anti-clockwise direction until you feel it engage.
4.3 Removing and installing selector mech‐
anism cover
Removing
– Remove selector lever handle
– Take out insert -1- for front ashtray by pressing button
-arrow-.
– Unscrew bolt -arrow - and remove housing for front ashtray.
– Unplug electrical connector.
multitronic 01J, front-wheel drive - Edition 11.2007
⇒ "4.4 Removing and installing tiptronic switch F189 ", page 18
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
⇒ page 17 .
Audi A8 2003 ➤
4. Servicing selector mechanism
17