Selector Lever Transmission Range Position Display Unit Y26 , Removing And Installing; Selector Lever Cable, Removing And Installing - Audi Q5 2008 Repair Manual

1.9 Selector Lever Transmission Range Po‐
sition Display Unit - Y26- , Removing
and Installing
Removing
– Press the button on the electro-mechanical parking brake to
activate it.
– Move the selector lever into "S" or "D/S".
– Carefully pry out the selector lever boot on the side using the
-3409- or a small screwdriver -arrows- and then fold it upward.
– Release the spring -2- and remove the Selector Lever Trans‐
mission Range Position Display Unit - Y26- -1- in direction of
-arrow-.
– Disconnect the connector.
Installing
Install in reverse order of removal.
1.10 Selector Lever Cable, Removing and In‐
stalling
Special tools and workshop equipment required
♦ Pry lever - 80-200-
♦ Trim Removal Wedge - 3409-
♦ Socket And Key - T40031-
Removing
– Press the button on the electro-mechanical parking brake to
activate it.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
– Move the selector lever into "D" or "D/S".
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi Q5 2008 ➤ , Audi Q5 China 2010 ➤
8-Speed Automatic Transmission 0BK AWD - Edition 04.2017
43
1. Selector Mechanism