Help Messages - Planmeca ProMax Technical Manual

Chapter C - HELP & ERROR MESSAGES

2 HELP MESSAGES

Error
Explanation
code
H101 Exposure switch
H102
H105 Emergency
pressed
H115 DEC related
H116
H141 Height movement
H142
H144
H151 Line voltage
H152
H161 Temperature
H162
H163
H164
H165
H166
C-2 Planmeca ProMax
released before end of exposure
continuously depressed or cable short
circuited
stop Height movement and radiation genera-
tion stopped due to the column emer-
gency STOP switch activation
DEC is receiving too much radiation
DEC is receiving too little radiation
stopped due to the column emergency
STOP switch activation (plate)
stopped due to interference with an
external object (former nut switch)
not possible because one (or more) of
the positioning control buttons or the
joystick is stuck
dropped too low during the exposure
is too low
of tube head too high
of lift motor too high
of the power supply (PSU) heatsink too
high
of tube head too low
The temperature of the tube head too
high for the exposure parameters.
Maximum tube head energy exceeded.
Lower the exposure parameters.
HELP MESSAGES
Comments
Exposure interrupted.
Release the exposure button.
When the STOP
released the X-ray unit is ready
for use again.
Change the exposure values.
Change the exposure values.
When the STOP
released the X-ray unit moves
again.
When the STOP switch (plate) is
released the X-ray unit moves
again.
Release the button/joystick that is
stuck.
Exposure interrupted.
Exposure not possible.
Exposure not possible before the
tube head has been cooled
down.
Lift motor cannot be run before
cooled down.
Exposure not possible before
cooled down. Check also that the
heatsink is attached properly on
the PSU.
Operating temperature too low.
Exposure not possible before the
tube head has been cooled
down.
Lower the exposure parameters.
Technical Manual
switch is
switch is