Switching X-Ray Unit On - Planmeca ProMax Technical Manual

Chapter A - GENERAL & TECHNICAL DATA
8

SWITCHING X-RAY UNIT ON

Stationary column top
A-24 Planmeca ProMax
On / off switch
NOTE To prolong the lifetime of the Planmeca ProMax X-ray
The on / off switch is located on the underside of the
stationary column top. When you switch the X-ray unit on the
main display will be shown on the control panel and the X-ray
unit will carry out a self-test which will last a few seconds.
The X-ray unit is then ready for use.
unit, always switch the X-ray unit off when it is not in
active use.
SWITCHING X-RAY UNIT ON
Technical Manual