Removing The Telescopic Column Rear Cover Plates - Planmeca ProMax Technical Manual

Chapter G - COLUMN

2.2 Removing the telescopic column rear cover plates

Remove the two rear cover plates of the telescopic column as follows. Switch the unit on and
drive the telescopic column to the uppermost position (Fig. 30, 1). Switch the unit off. Detach
the upper inner corner of the cover plate by carefully pulling it outwards (Fig. 30, 2). Detach
the cover plate by pushing the cover plate inwards (see small arrows in the figure below) (Fig.
30, 3).
Figure 30
G-10 Planmeca ProMax
2
3
1
3
REMOVING THE COVERS
Technical Manual