Help Messages - Planmeca ProMax 2D User Manual

13 HELP MESSAGES

13 HELP MESSAGES
Code
H101 Exposure switch
H102
H105 Emergency stop but-
ton
H115 DEC
H116
H142 Height movement
H144
H151 Line voltage
H152
72 Planmeca ProMax 2D & 3D s & 3D Classic
The X-ray unit incorporates a self-checking feature that
monitors the operation of the unit. If the system detects an
operating error a help message (e.g. H101) appears on
the touch screen.
The X-ray unit will not accept any commands from the
user until the help message is cleared from the touch
screen. Clear the message by touching the green check
mark.
The following list shows, in numerical order, all the help
messages that can appear.
Explanation
The exposure button was released
before end of exposure.
The exposure button is stuck or the
cable is short circuited.
The emergency stop button has been
activated.
DEC is receiving too much radiation.
DEC is receiving too little radiation.
Height movement is not possible
because the stop plate at the bottom of
the column was activated.
Height movement is not possible
because one (or more) of the
positioning control buttons or the
positioning joystick is stuck.
The line voltage was too low during
exposure.
The line voltage is too low.
Comments
Guide the patient away from the
X-ray unit before moving the
C-arm.
Press and hold down the
exposure button for the entire
duration of the exposure.
Release the exposure button.
If necessary, contact your
service technician to replace the
exposure switch.
All movements of the X-ray unit
are blocked, no radiation is
generated.
Guide the patient away from the
X-ray unit. Then release the
emergency stop button to
resume normal operation.
Change the exposure values.
Change the exposure values.
Clear any obstruction before
moving the column again.
Release the button / joystick.
Exposure was interrupted.
Contact your service technician
for help.
Exposure is not possible.
Contact your service technician
for help.
User's Manual (2D)