Help Messages - Planmeca ProMax X-ray User Manual

HELP MESSAGES

17 HELP MESSAGES
Help
Explanation
code
H101 Exposure switch
H102
H141 Height movement
H142
H143
H151 Line voltage
H152
H161 Temperature
H162
H163
H171 User handled fea-
tures
H172
H175
H176
H177
H178
H179
H180
104 ProMax X-ray unit with Dimax3
The following is a list of the help messages. These
messages appear in the display if you are using the unit
incorrectly, or if the function is not allowed for some
reason. The help message disappears automatically
when the situation is corrected, e.g. the pressed key is
released.
released before end of exposure
continuously depressed or cable short
circuited
stopped due to the column emergency
stop switch activation (plate)
stopped due to interference with an
external object (former nut switch)
not possible because the (optional)
STOP switch is activated
dropped too low during the exposure
is too low
of tube head too high
of lift motor too high
of the power supply heatsink too high
Dimax3 sensor head not installed
properly to C-arm
Dimax3 sensor head not installed
properly to cephalostat
PC program selection in conflict with
selected ProMax program
Safety area limit violation in tomography
mode. Change layer thickness, position
or angle
One or more image layers will not be
exposed with these settings
Imaging impossible with selected
settings
Enter cassette number.
AEC not available.
Comments
Exposure interrupted.
Exposure not possible.
Exposure interrupted.
Exposure not possible.
Exposure not possible before
cooled down.
Lift motor cannot be run before
cooled down.
Exposure not possible before
cooled down.
User's Manual